Humminbird XP-9-20-T In-Hull Puck Transducer
|
Humminbird TG-W Temperature Sensor
|
Humminbird AS-GR16 16 Channel GPS Receiver |
Humminbird TS-W Temp/Speed Sensor
|
Humminbird XNT-9-20-T Transom Mount Transducer - 83/200 kHz
|
730021-1
Humminbird SW Transom Mount Speed Sensor |
Humminbird TS2-W Transducer Switch 2 Transducers 1 Unit
|
Humminbird US2-W Transducer Switch 1 Transducer 2 Units
720014-1 |
Humminbird EC-W30 Transducer Extension Cable - 30'
|
Humminbird XPT-9-20-T Portable Transducer w/ Temp
|
Humminbird XTH-9-20 Bronze Thru-Hull Transducer - 83/200 kHz
|
Humminbird EC-W10 Transducer Extension Cable - 10'
|
Humminbird IDMK-M In-Dash Mounting Kit
Provides the capability to install a unit in the dash. |
Humminbird MS-M Quick Disconnect Mount
|
Humminbird PC-10 6' Power Cable
|
Humminbird TS-WFM Flush Mount Temp/Speed Sensor
|
Humminbird XTM-9-20T Trolling Motor Transducer
Trolling Motor Mount Transducers are designed to mount on to the body of most trolling motors. A low profile shape reduces drag in the water and minimizes interference with weeds. Trolling Motor Transducers are often used in conjunction with the standard Transom Mount Transducer and connected by a switch to allow the fishfinder to display information from either the transom or the trolling motor. Some Transom Mount Transducers can be converted to Trolling Motor Mount by purchasing a Trolling Motor Adapter. |
Humminbird XTH-9-20-P Plastic Thru Hull Transducer
Plastic Thru-Hull Transducers are for large boats and for boats with in-board motors that make typical Transom Mount Transducers ineffective. They are not recommended for trailered boats as the transducer is not flush with the hull. Plastic Thru-Hull Transducers require that a hole be drilled in the hull and the shaping of a fairing block. Professional installation is recommended. Bronze Thru-Hull Transducers are an alternative to Plastic Thru-Hull Transducers.
|
Humminbird XAP-9-20 Angled Puck Transducer
Inside Hull Transducers mount to the inside of most fiberglass boat hulls and transmit the sonar signal through the hull. On hulls with a deadrise less than 15 degrees, a flat bottom transducer should be used. For angles greater than 15 degrees, an angled transducer is recommended to assure the sonar signal travels downward.
|
GCB AGM Battery
12 volt Battery
7-Amp Hour AGM battery for use with Humminbird PTC U or PTC UNB soft sided portable cases.
|
DBK2 2nd Station Dual Beam Trolling Motor Transducer Kit
The Mount and Transducer Kits include everything necessary to set up a second mounting station with a dedicated trolling motor transducer.
Description: Dual Beam Transducer Kit - includes a XTM 9 20 T, MS M, AND PC 10 |
