Humminbird XP-9-20-T In-Hull Puck Transducer

Humminbird TG-W Temperature Sensor

Humminbird AS-GR16 16 Channel GPS Receiver

Humminbird TS-W Temp/Speed Sensor

Humminbird XNT-9-20-T Transom Mount Transducer - 83/200 kHz

730021-1

Humminbird SW Transom Mount Speed Sensor

Humminbird TS2-W Transducer Switch 2 Transducers 1 Unit

Humminbird US2-W Transducer Switch 1 Transducer 2 Units

720014-1

Humminbird EC-W30 Transducer Extension Cable - 30'

Humminbird XPT-9-20-T Portable Transducer w/ Temp

Humminbird XTH-9-20 Bronze Thru-Hull Transducer - 83/200 kHz

Humminbird EC-W10 Transducer Extension Cable - 10'

Humminbird IDMK-M In-Dash Mounting Kit

Provides the capability to install a unit in the dash.

Humminbird MS-M Quick Disconnect Mount

Humminbird PC-10 6' Power Cable

Humminbird TS-WFM Flush Mount Temp/Speed Sensor

Humminbird XTM-9-20T Trolling Motor Transducer

Trolling Motor Mount Transducers are designed to mount on to the body of most trolling motors. A low profile shape reduces drag in the water and minimizes interference with weeds. Trolling Motor Transducers are often used in conjunction with the standard Transom Mount Transducer and connected by a switch to allow the fishfinder to display information from either the transom or the trolling motor. Some Transom Mount Transducers can be converted to Trolling Motor Mount by purchasing a Trolling Motor Adapter.

Humminbird XTH-9-20-P Plastic Thru Hull Transducer

Plastic Thru-Hull Transducers are for large boats and for boats with in-board motors that make typical Transom Mount Transducers ineffective. They are not recommended for trailered boats as the transducer is not flush with the hull. Plastic Thru-Hull Transducers require that a hole be drilled in the hull and the shaping of a fairing block. Professional installation is recommended. Bronze Thru-Hull Transducers are an alternative to Plastic Thru-Hull Transducers.

Humminbird XAP-9-20 Angled Puck Transducer

Inside Hull Transducers mount to the inside of most fiberglass boat hulls and transmit the sonar signal through the hull. On hulls with a deadrise less than 15 degrees, a flat bottom transducer should be used. For angles greater than 15 degrees, an angled transducer is recommended to assure the sonar signal travels downward.

DBK2 2nd Station Dual Beam Trolling Motor Transducer Kit

 The Mount and Transducer Kits include everything necessary to set up a second mounting station with a dedicated trolling motor transducer. Description: Dual Beam Transducer Kit - includes a XTM 9 20 T, MS M, AND PC 10