Humminbird SW Transom Mount Speed Sensor
|
Humminbird TG-W Temperature Sensor
|
Humminbird IDMK-M In-Dash Mounting Kit
Provides the capability to install a unit in the dash. |
Humminbird TS-W Temp/Speed Sensor
|
Humminbird TS-WFM Flush Mount Temp/Speed Sensor
|
Humminbird EC-TS10 Temp/Speed Extension Cable - 10'
|
Humminbird TS2-W Transducer Switch 2 Transducers 1 Unit
|
Humminbird XNT-9-20-T Transom Mount Transducer - 83/200 kHz
|
Humminbird EC-W30 Transducer Extension Cable - 30'
|
Humminbird XPT-9-20-T Portable Transducer w/ Temp
|
Humminbird XTH-9-20 Bronze Thru-Hull Transducer - 83/200 kHz
|
Humminbird EC-W10 Transducer Extension Cable - 10'
|
Humminbird US2-W Transducer Switch 1 Transducer 2 Units
The Fishfinder Switch connects two fishfinders to one transducer.
|
Humminbird MS-M Quick Disconnect Mount
|
Humminbird PC-10 6' Power Cable
|
Humminbird XAP-9-20 Angled Puck Transducer
Inside Hull Transducers mount to the inside of most fiberglass boat hulls and transmit the sonar signal through the hull. On hulls with a deadrise less than 15 degrees, a flat bottom transducer should be used. For angles greater than 15 degrees, an angled transducer is recommended to assure the sonar signal travels downward.
|
Humminbird MC-W Mounting Bracket Cover
The Mount Cover provides protection for the unit's connector panel, keeping rain and dirt out of the electrical connections while the unit is not in use. Made of durable textured vinyl.
|
Humminbird MHX-PT2 Portable Mounting Hardware
Mounting hardware and suction cup for portable transducers |
Humminbird XTH-9-20-P Plastic Thru Hull Transducer
Plastic Thru-Hull Transducers are for large boats and for boats with in-board motors that make typical Transom Mount Transducers ineffective. They are not recommended for trailered boats as the transducer is not flush with the hull. Plastic Thru-Hull Transducers require that a hole be drilled in the hull and the shaping of a fairing block. Professional installation is recommended. Bronze Thru-Hull Transducers are an alternative to Plastic Thru-Hull Transducers.
|
UNIT COVER
All Matrix (except Matrix 97) and 500 Series
Humminbird UC-M |
Humminbird MHX-SHS Transom Mount Mounting Hardware
|
Humminbird XTM-9-20T Trolling Motor Transducer
Trolling Motor Mount Transducers are designed to mount on to the body of most trolling motors. A low profile shape reduces drag in the water and minimizes interference with weeds. Trolling Motor Transducers are often used in conjunction with the standard Transom Mount Transducer and connected by a switch to allow the fishfinder to display information from either the transom or the trolling motor. Some Transom Mount Transducers can be converted to Trolling Motor Mount by purchasing a Trolling Motor Adapter. |
DBK2 2nd Station Dual Beam Trolling Motor Transducer Kit
The Mount and Transducer Kits include everything necessary to set up a second mounting station with a dedicated trolling motor transducer.
Description: Dual Beam Transducer Kit - includes a XTM 9 20 T, MS M, AND PC 10 |
|
