A/C,PC adapter, 7pin (US)

This adapter allows you to connect your GPS unit to AC power (U.S., 110-volt) and to your PC. Features standard 9-pin D connector.

Cigarette lighter adapter

This adapter works with the PC interface cable if you're using your GPS unit with a PC where there's no A/C power. Plugs into any standard cigarette lighter receptacle.

GA 30 remote Marine Antenna

Includes pole/surface/under-deck mount capability with mounting brackets, 30 ft. cable and BNC connector

Replacement GA 26C low-profile remote automobile antenna

 This new and improved remote antenna runs on a lower voltage so battery drain is minimized. Comes with two mounting options. Magnetic mount for the outside of your vehicle or boat. Suction mount holds antenna in place against the inside of your windshield or window. With 8 feet of cable and BNC connector.

GA 26/27 series Flange Antenna Mount

If you're mounting a GA 26/27 and GA 26C/27C antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

GA 28/GPS35/GPS36 series Flange Antenna Mount

If you're mounting a GA 28 antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

GA 26/27 series Antenna Suction Cup Mount (replacement)

So the suction cup mount that came with your GA 26/27 or GA 26C/27C antenna is gone and you're lost without it. No problem. Here's the replacement.

8 ft. extension cable for GA 26 series antenna

If the 8 feet of cable that comes with the GA 26C remote antenna isn't enough, here's another 8 feet.

010-10152-00

USB to RS232
Converter Cable

Want to connect your GPS to your PC but don't have a 9-pin serial port connection? This cable will get you hooked. Using this converter cable and the PC interface cable for your unit, you can transfer maps, waypoints, routes and tracks between MapSource and your GPS.