GA 29 Low Profile Marine Antenna with 30ft Cable & BNC

If you're mounting your GPS unit below deck, you'll need this remote marine antenna to receive GPS signals. Comes with 30 feet of cable and BNC connector. (Can be mounted flush or pole.)

MapSource BlueChart

Transducers
(click here)

Transducers, Transducers, Transducers

Transducer everything!

(click here)

INLAND LAKES CONTINENTAL U.S.

8 ft. extension cable for GA 26 series antenna

If the 8 feet of cable that comes with the GA 26C remote antenna isn't enough, here's another 8 feet.

Retrofit adapter cable

No need to yank out the existing wiring to your transducer and power supply if you're upgrading to a newer Fishfinder or GPS model with a single port. This cable plugs into the back of the new unit and then splits to connect to the transducer and power supply.

Replacement GA 26C low-profile remote automobile antenna

This new and improved remote antenna runs on a lower voltage so battery drain is minimized. Comes with two mounting options. Magnetic mount for the outside of your vehicle or boat. Suction mount holds antenna in place against the inside of your windshield or window. With 8 feet of cable and BNC connector.

USB Data Card Programmer

No more twiddling your thumbs and burning your GPS batteries while you download map detail to the data card. The USB data card programmer downloads maps directly to the data card in a fraction of the time. Connects to the USB port on your PC.

National Parks East Topo

MapSource WorldMap

Cigarette lighter adapter

Just another option for powering your fishfinder or GPS unit. Plugs into any standard cigarette lighter receptacle. Also works with the PC interface cable.

010-10208-00

MapSource Topo

GA 26/27 series Flange Antenna Mount

If you're mounting a GA 26/27 and GA 26C/27C antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

A/C,PC adapter, 18pin (US)

This adapter allows you to connect your GPS unit to AC power (U.S., 110-volt) and to your PC. Features standard 9-pin D connector to computer serial port.

MapSource National Parks West Topo

GA 28/GPS35/GPS36 series Flange Antenna Mount

If you're mounting a GA 28 antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

Trip & Waypoint Manager

MapSource National Parks Central Topo

GA 26/27 series Antenna Suction Cup Mount (replacement)

So the suction cup mount that came with your GA 26/27 or GA 26C/27C antenna is gone and you're lost without it. No problem. Here's the replacement.