MapSource National Parks East Topo

MapSource BlueChart

MapSource WorldMap

MapSource National Parks Central Topo

MapSource National Parks West Topo

MapSource Topo

Trip & Waypoint Manager

8 ft. extension cable for GA 26 series antenna

If the 8 feet of cable that comes with the GA 26C remote antenna isn't enough, here's another 8 feet.

A/C,PC adapter, 7pin (US)

This adapter allows you to connect your GPS unit to AC power (U.S., 110-volt) and to your PC. Features standard 9-pin D connector.

USB Data Card Programmer

No more twiddling your thumbs and burning your GPS batteries while you download map detail to the data card. The USB data card programmer downloads maps directly to the data card in a fraction of the time. Connects to the USB port on your PC.

Swivel mount

This very cool ball and socket mount works on any flat surface and takes up a tiny footprint. Allows you to swivel and tilt your fishfinder or GPSMAP unit to get the best viewing angle.

Bracket ONLY works with external antenna.

Cigarette lighter adapter

This adapter works with the PC interface cable if you're using your GPS unit with a PC where there's no A/C power. Plugs into any standard cigarette lighter receptacle.

Power/data cable (bare wires)

This power and data cable has bare wires at the end so you can hard wire your GPS directly to a DC power source or some other electronic device. This allows you to send speed and position data to devices such as a chartplotter, computer, auto pilot, radar, etc.

INLAND LAKES CONTINENTAL U.S.

GA 29 Low Profile Marine Antenna with 30ft Cable & BNC

If you're mounting your GPS unit below deck, you'll need this remote marine antenna to receive GPS signals. Comes with 30 feet of cable and BNC connector. (Can be mounted flush or pole.)

Replacement GA 26C low-profile remote automobile antenna

Replacement GA 26C low-profile remote automobile antenna

This new and improved remote antenna runs on a lower voltage so battery drain is minimized. Comes with two mounting options. Magnetic mount for the outside of your vehicle or boat. Suction mount holds antenna in place against the inside of your windshield or window. With 8 feet of cable and BNC connector.

GA 26/27 series Antenna Suction Cup Mount (replacement)

GA 26/27 series Flange Antenna Mount

If you're mounting a GA 26/27 and GA 26C/27C antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

GA 28/GPS35/GPS36 series Flange Antenna Mount

If you're mounting a GA 28 antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.